Samsung Appliance Error Codes Explained

Loading...

Short answerSamsung often shows one fault in several spellings: older models use an "E" suffix and newer ones a "C" (4E → 4C, 5E → 5C), and the display can turn S into 5 or O into 0. Look up your code in any of its forms below. Many codes clear after a power cycle; if one comes back, the table shows the part to check.

Notice: Samsung warns that a reset clears the stored code but not the fault. On refrigerators, don't reset before a technician visit — it erases the error history.

How to reset

  • Washer / dryer: unplug or switch off the breaker for 1–5 minutes, then power on.
  • Dishwasher: troubleshoot first, then breaker off for 30 seconds to 2 minutes.
  • Refrigerator: unplug about 5 minutes — Samsung rarely recommends it.
  • Washer calibration (fixes Ub/UE, weak spin): empty the tub, hold Temp + Delay End 3 s until Cb shows, press Start. Turn off when End shows.

↔ Tip: swipe the code tables sideways to see all columns

Washer codes

Code (all forms) Meaning What to try Likely part Pro?
5C / 5E / SE / nd No drain Clean the pump filter behind the front access door; check the hose height (18–96") and depth (6–8" into the standpipe) Drain pump, filter, hose If it persists
4C / 4E / nF Not filling Open both valves, check hoses and inlet screens Water inlet valve If it persists
4C2 / 4E2 Hot and cold reversed Swap the hoses — Samsung says service is never needed — No
dC / dE / dS / FL / LO Door not closed and locked Remove anything caught in the door, close fully Door lock / switch If it persists
Ub / UE / Ur Unbalanced load Redistribute, run calibration Shock absorbers if chronic No
SUd / Sd Excess suds Use HE detergent in the right amount — No
OC / OE Overflow Check hose and supply Pressure sensor, inlet valve Yes
LC / LE / 1C Water level or leak Check for leaks and kinked hoses Level sensor, leak sensor If it persists
3C / 3E Motor error Power cycle 2–3 min Drive motor, hall sensor, PCB Yes
HC / HE Heater error Power cycle Wash heater, thermistor Yes
Cb Calibration (not an error) Let it finish — No

Dryer codes

Code Meaning What to try Likely part Pro?
Clg / C9 / C80 / C90 Vent blocked (80%, 90%) Clean the lint filter and exhaust vent Vent duct No
HC / hE Overheating (sometimes too little heat) Clean lint screen and vent; electric: check for low voltage Heating element, thermal fuse, thermistor If it persists
HC2 Gas ignition error Power off 2–3 min and restart Igniter, flame sensor, gas valve coils Yes
tS / tE / tC Temperature sensor Clean lint screen and vent Thermistor, high-limit thermostat If it persists
dC / dE / dF Door error Check the latch, close fully Door switch / latch If it persists
9C1 / 9E Voltage error Dedicated circuit, no extension cord Power cord, PCB If it persists
3C Motor error Power off 2–3 min, restart Drive motor, belt, idler Yes
oD Dry time error Restart Moisture sensor bars If it persists

Dishwasher codes

Code Meaning What to try Likely part Pro?
5C / 5E / SC Drain error Clear the disposal, remove the knockout cap, check the hose for kinks, clean the filter Drain pump, hose, filter If it persists
4C / 4E Water supply Open the valve, straighten the hose Inlet valve If it persists
LC / LE Leak sensor detects moisture Don't overfill detergent, check hose and door seal, level the unit Door gasket, hoses, leak sensor If it persists
1E / IE WaterWall: clogged filter. Rotary: heater error Clean the fine filter Filter / heater If it recurs
3C Wash pump failed Restart Circulation pump motor Yes
7E / 7C WaterWall reflector can't move Remove items blocking the vane; breaker off 2 min Reflector, vane (rare) Rarely
HE / HC / tE Heater or temperature sensor Run Normal; power cycle Heater, thermistor If it persists
OC / OE Too much water Same checks as 5C Inlet valve, float Yes

Refrigerator codes

Code Meaning What to try Likely part Pro?
OF OF / O FF Cooling Off (demo) mode — not a fault Hold the top two left buttons 8 s (French door: Power Freeze + Freezer) — No
21E Freezer fan error Defrost; check doors and gaskets seal Freezer fan motor, defrost system If it recurs
22E / 22C Fridge fan error Unplug, doors open several hours, plug back in Fridge fan motor, defrost parts If it recurs
40E / 40C Ice room fan Request service Ice room fan motor Yes
39E / 39C Ice maker function Press the ice maker Test button Ice maker assembly Yes
5E Fridge defrost sensor Request service Defrost sensor Yes
83E / 84C Compressor current / lock Unplug 60 s; service if it returns Compressor, inverter PCB Yes
85E / 86E Low or high voltage Unplug 60 s Household supply, PCB If it returns

Range and oven codes

Code Meaning What to try Likely part Pro?
-dC- / -dE- Flex Duo divider not detected Reinstall the divider fully Partition switch If it persists
C-d0 Stuck key Clean and dry the buttons; power off 30 s Touch keypad If it persists
C-d1 Door lock malfunction Power off at least 30 s Door lock assembly Yes
C-20 / C-22 Temperature sensor Power off 30 s Oven temperature sensor Yes
C-F0 Board communication error Reset power Control board Yes
tESt Demo mode — no heating Exit demo mode (see manual) — No
bAd LinE Power connection wired wrong Reconnect correctly Power cord / terminal block Electrician

Find your model number

Ranges: open the oven door and check the top-left of the frame, or the left side of the bottom drawer frame. Washers and dryers: around the door opening or on the back (front-load); on the back (top-load). → Model Number Locator.

FAQ

What does 5C mean on a Samsung washer?
It can't drain. Clean the pump filter and check the drain hose.
Why does my Samsung fridge say OF OF?
It's in Cooling Off (demo) mode — nothing cools. Exit the mode; no service is needed.
What does dC mean on a Samsung washer?
The door isn't detected as closed and locked.
How do I fix 22E on a Samsung fridge?
The fridge fan is usually iced. Unplug, leave the doors open for several hours, then plug back in.
Will resetting clear the error?
It clears the code but not the cause. Troubleshoot first.

Based on Samsung US support pages. Last reviewed: September 2026.